Digital Power Measurement System and Multifunction Transducer

Multi-Function Transducer is a perfect solution for manyvaried applications Configured by User (or factory configured as needed) Outperforms many single function instruments Excellent for replacement strategy: One unit replaces many makes and models Excellent for back-up strategy: One unit on shelf backs up many varied units in the field. Highly Accurate Digital Communications Economical Remote Display Option available Compact 3.75" x 5.375" x 6.5" Space Saving Size Transformer Loss Compensation (TLC)

SPECIFICATIONS

• Programmable Configuration
  2 element for 3 phase 3 wire delta
  2 1/2 element for 3 phase 4 wire wye
  3 element for 3 phase 4 wire wye

• Measured and/or calculated quantities
  Watts – per phase and total
  Vars – per phase and total
  Voltage – phase to neutral (4 wire), phase to phase (3 wire) Current – phase and neutral (calculated)
  Volt Amps – per phase and total
  Frequency
  Distortion – Total Harmonic Distortion of each voltage and current
  Watthours – delivered and received
  Varhours – delivered and received
  Power Factor – per phase and system

• Inputs
  Current
  Nominal – 5 amps
  Operating Range – 0 to 10 amps
  Voltage
  Nominal – 120 volts
  Operating Range – 85 to 150 volts
  Frequency
  45 to 65 Hertz
  Power Supply
  95 to 265 VAC @ 50/60 Hz or DC

Outputs
3 Channel Analog
Option X1: 0 to ± 1 ma, maximum 10 volt compliance
Option XA: 4 to 20 ma, maximum 12 volt compliance

6 Channel Digital – Option KYZ
Solid state rated 50 ma @135 VAC/VDC with less than 5 volt drop

Mechanical
Size: 3.75" x 5.375" x 6.5"
Weight: 2.6 lbs. (1.2 kg.)

Communications
Hardware Protocol: RS-232 (full duplex) or RS-485 (half duplex)
Software Protocol: Modbus or DNP 3.0

Ametek Power Instruments, Canada , 11 Clinton Court, Bowmanville, ON L1C 4K7. Tel: 905-623-0098; Fax: 905-623-9498.