News | July 8, 2014

Efficient Power Conversion (EPC) Widens The Performance Gap With The Aging Power MOSFET With ‘Off-The-Shelf' High Performance Gallium Nitride Power Transistors

EL SEGUNDO, CALIF.--(BUSINESS WIRE)--

Efficient Power Conversion Corporation (EPC) announces the introduction of six new-generation power transistor products and corresponding development boards. Ranging from 30 V to 200 V, these products provide significant reduction in RDS(on) greatly increasing their output current capability in applications such as high power density DC-DC converters, Point-of-Load (POL) converters, synchronous rectification in DC/DC and AC/DC converters, motor drives, LED lighting, and industrial automation.

New eGaN FET Products with Supporting Development Boards

EPC Part
Number

    Voltage    

Max R DS(on)
(mΩ)

(V GS = 5 V)

   

Max. Peak Pulsed
I D (A) (25°C,

T pulse = 300 µs)

    T J (°C)    

Half-Bridge
Development Boards

                            Standard

Low Duty
Cycle

EPC2023

    30     1.3     590     150    

EPC9031

EPC9018

EPC2024

    40     1.5     550     150    

EPC9032

 

EPC2020

    60     2     470     150    

EPC9033

 

EPC2021

    80     2.5     420     150    

EPC9034

EPC9019

EPC2022

    100     3.2     360     150    

EPC9035

 

EPC2019

    200     43     42     125    

EPC9014

 
  • Lower On-resistance (RDS(on))

The new family of eGaN FETs cuts on-resistance (RDS(on)) in half, enabling high current, high power density applications.

  • Improved Figure of Merit (FOM)

The latest generation of eGaN FETs cuts the hard-switching FOM in half compared with the previous generation for improved switching performance in high frequency power conversion applications.

  • Extended Voltage Range

Extending the performance benefits of GaN to 30 V enables higher power DC-DC converters, Point-of-Load (POL) converters, synchronous rectifiers for isolated power supplies, PCs, and servers.

  • Better Thermal Performance

Increased temperature capabilities and improved die layout improve the thermal and electrical performance of the Gen 4 family of devices allowing for higher power operation under all conditions.

Demonstrated Power Conversion Efficiency Improvements

To demonstrate the improved performance of these new eGaN FETs, two buck converters were built. The EPC9018 combines the 30 V EPC2023 FET as the synchronous rectifier with the 40 V EPC2015 as the control switch of a 12 V – 1.2 V DC-DC point of load (POL) converter.

The 12 V to 1.2 V, 40 A POL converter operating at switching frequency of 1 MHz achieved efficiencies above 91.5% and demonstrated the superior in-circuit performance of the latest generation of eGaN power devices compared to the state-of-the-art Si MOSFET modules.

The EPC9019, a 48 V – 12 V converter, uses the 80 V, EPC2021 as the synchronous rectifier switch with the 100 V EPC2001 as the control switch. The results of this 48 V to 12 V, 30 A non-isolated DC-DC intermediate bus converter operating at a switching frequency of 300 kHz achieved efficiencies above 98%, again significantly outperforming a comparable converter using state-of-the-art silicon power MOSFETs.

Detailed results of these in-circuit demonstrations of eGaN FETs can be seen at http://bit.ly/EPCAN017.

Development Boards

To simplify the evaluation process of the latest high performance eGaN FETs, development boards are available to support easy “in circuit” performance evaluation of each new product being introduced (reference table given above). These boards include all the critical components on a single board that can be easily connected into any existing converter.

The EPC9014 and EPC9031 through EPC9034 development boards are half-bridge configurations with onboard gate drives, featuring various eGaN power transistors. All boards are 2” x 1.5” and contain two eGaN FETs using the Texas Instruments LM5113 gate driver, supply and bypass capacitors. Each board contains all critical components and layout for optimal switching performance.

The EPC9018 and EPC9019 development boards mentioned above are also available for easy “in circuit” performance evaluation.

Price and Availability

Products

Pricing for the EPC2019 – 24 power transistors at 1K units starts at $3.14 each and are available for immediate delivery from Digi-Key at http://digikey.com/Suppliers/us/Efficient-Power-Conversion.page?lang=en

Development Boards

Pricing for corresponding development boards start at $104.40 each and are available for immediate delivery from Digi-Key at http://digikey.com/Suppliers/us/Efficient-Power-Conversion.page?lang=en

Additional Information

Design Information and Support for eGaN FETs:

About EPC

EPC is the leader in enhancement mode gallium nitride based power management devices. EPC was the first to introduce enhancement-mode gallium-nitride-on-silicon (eGaN) FETs as power MOSFET replacements in applications such as DC-DC converters, wireless power transfer, envelope tracking, RF transmission, solar micro inverters, remote sensing technology (LiDAR), and class-D audio amplifiers with device performance many times greater than the best silicon power MOSFETs.

Visit our web site: www.epc-co.com

Sign-up to receive EPC updates via email: http://bit.ly/EPCupdates or text "EPC" to 22828

Follow EPC on Twitter at http://twitter.com/#!/EPC_CORP

Like EPC on Facebook at http://www.facebook.com/EPC.Corporation

eGaN is a registered trademark of Efficient Power Conversion Corporation, Inc.


Copyright Business Wire 2014

Newsletter Signup
Get the latest industry news, insights, and analysis delivered to your inbox.
Join your peers